Cat-Back Milltek Audi RS5 B9.5 - no primary, non-resonated - polished Dual Oval Tips - Coupe - Road+, facelift, with valves
Milltek Sport stainless steel exhaust for Audi RS5 B9.5, non-resonated (no resonator), with valves. A sporty, deep tone without gimmicks, from the British exhaust specialist. 2 oval outlets, polished stainless steel finish.
Milltek Sport Exhaust System for Audi RS5 B9.5
Replacing the stock exhaust with a Milltek Sport exhaust system brings back the character that the factory setup stifles in your Audi RS5 B9.5: a rounder tone at idle that opens up cleanly through the rev range, without gimmicks.
Technical Specifications
- Milltek Part Number: SSXAU991
- Part Type: Exhaust system
- Configuration: non-resonated (without resonator), with valves
- Details: No primary muffler, no resonator; dual oval outlets in polished stainless steel
- Tube Diameter: 70 mm (2.75 inches)
- Outlets: 2 oval outlets
- Tip Finish: polished stainless steel
- Installation Details: Road+ version (ECE rear muffler), with valves (Engines included for facelift versions)
- Material: aerospace-grade stainless steel
- Manufacturer: Milltek Sport (UK)
Compatible Vehicles
- Audi RS5 B9.5 2.9 V6 T (Coupe, 2019-2025, no DPF)
Not sure about compatibility with your vehicle? Contact us with your VIN before ordering.
Most Frequently Asked Questions
- Resonated or non-resonated? This version is non-resonated (no resonator): it is the most expressive, with more crackle on lift-off. The trade-off is that a slight drone may appear at certain engine speeds on long journeys. If you do a lot of highway driving, compare it with the resonated version.
- What about the neighbors in the morning? The valves are controlled as on the factory system: closed and quiet on startup or in comfort mode, fully open in sport mode.
- Installation: the system uses the original mounting points. A properly equipped repair shop usually fits it in one to two hours.
Why Choose Milltek Sport?
Milltek Sport designs and manufactures its exhausts in England, using mandrel-bent tubes to preserve the internal diameter and a fit developed on the vehicle. The result: a clean installation, no modification needed, and a tone tuned to stay pleasant for everyday driving.
Further Reading
| Materials | Stainless steel |
|---|---|
| Diameter | 70mm (2.75 in) |
| Product family | Exhausts |
| Exhaust | Cat-back exhaust |
| Exhaust options | Polished stainless tips Without resonator (straight pipe) with valves |
| Homologation: | No homologation |
Product Review
Average rating
-
Reviews (0)
- All reviews (0)
- Has image/video (0)
- Excellent (0)
- Good (0)
- Medium (0)
- Poor (0)
- Terrible (0)
-
Latest
- Latest
- Oldest
- High rating
- Low rating
- Helpful
-
Latest
- Latest
- Oldest
- Helpful
There are no available reviews. Write your review.