Cat-back Milltek Audi A1 8X 1.4 TFSI 2010-2018 / VW Polo 6R GTI 1.4 TSI 2010-2015 - non-resonated - Twin GT80 Black Cerakote Tip

Milltek Sport cat-back exhaust for Audi A1 8X / Volkswagen Polo 6R GTi

Replacing the factory exhaust with a Milltek Sport cat-back exhaust brings back the character that the engine of your Audi A1 8X / Volkswagen Polo 6R GTi suppresses from the factory: a rounder sound at idle that opens up clearly at higher RPM, without gimmicks.

Technical specifications

• Milltek part number: SSXAU459
• Part type: Exhaust system
• Configuration: non-resonated (no resonator)
• Detail: No resonator - dual GT80 black Cerakote tips
• Tube diameter: 70 mm (2.75 inches)
• Tips: two 80 mm GT80 tips
• Tip finish: black Cerakote (high-temperature ceramic coating)
• Fitting information: (For models with and without Xenon)
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (UK)

Compatible vehicles

• Audi A1 8X 1.4 TFSi 150 hp (S-Line only, 2WD, 2015-2018)
• Audi A1 8X 1.4 TFSi 185 hp (S-Line only, S-Tronic, 2WD, 2010-2015)
• Volkswagen Polo 6R GTi 1.4 TSI 180 hp (DSG 7, 2010-2015)

Not sure about compatibility with your vehicle? Contact us with your VIN before ordering.

Most frequently asked questions

• Resonated or non-resonated? This version is non-resonated (no resonator): it is the most expressive, with more crackle on lift-off. On the downside, a slight drone may occur at certain engine speeds on long journeys. If you do a lot of motorway driving, compare it with the resonated version.
• Fitting: the system uses the original mounting points. A workshop with the right equipment typically fits it in one to two hours.

Why choose Milltek Sport?

A benchmark among European tuners, Milltek Sport develops each of its systems directly on the vehicle. Mandrel-bent tubing, clean welds and aerospace-grade stainless steel make for an exhaust that lasts and sounds right.

For more information

• Resonated or non-resonated cat-back: which one should you choose for your car?