Coilovers STXA ST Suspensions VOLKSWAGEN Golf VII

Years: 11/12-

Maximum permitted front axle load (in Kg): -1080

Maximum permitted rear axle load (in Kg): -980

Front lowering in mm: 35-65

Rear lowering in mm: 35-65

Derived from motorsport, the STXA range allows adjustment of BOTH height AND firmness. Height adjustment at the front and rear (on vehicles that allow it) via a disc located on the threaded body of the shock absorber. Very precise firmness adjustment via a progressive dial located at the top of the shock absorber rod. For everyone who needs to fine-tune their setup to achieve a personalized "setup". Galvanized treatment plus anti-corrosion coating for increased longevity.

ST Suspensions coilovers are supplied in sufficient quantity to equip the vehicle. They fit in place of the original suspension, without modification. For example, if the vehicle only has springs at the rear as original equipment, the same will apply with these ST Suspensions kits.

The only models sold with strut mounts are the STXTA coilovers. For any other model, please make sure to equip yourself with original strut mounts for installation. ST Suspensions kits are supplied bare (shock absorber cartridges and springs where applicable), unless an accessory essential for lowering is required. The struts are made of galvanized steel.

ST Suspensions is a KW brand, and products under this brand are manufactured by KW.

We remain at your disposal via the contact form for any other information.

Technical note to consider before ordering:

ON models equipped with M-Tech, use only lowering springs kits. The lowering will be 20mm less than the value indicated

FOR models with Ø 55mm strut on the front axle.

The original electronic suspension control system must be deactivated. The deactivation kit is available under reference KW 68510342.