Cat-Back Milltek Volkswagen Golf Mk7 R 2.0 TSI 300hp 2014-2016 - non-resonated - Quad GT100 Polished Tips - no valves

Milltek Sport exhaust system for Volkswagen Golf Mk7 R

Replacing the original system with a Milltek Sport exhaust brings back the character that the stock setup of your Volkswagen Golf Mk7 R chokes: a rounder sound at idle that opens up cleanly through the rev range, with no gimmicks.

Technical specifications

• Milltek part number: SSXVW408
• Part type: Exhaust system
• Configuration: non-resonated (no resonator), no valves
• Details: No resonator - quad GT100 polished stainless outlets
• Tube diameter: 76.2 mm (3 in)
• Outlets: 4 GT100 outlets of 100 mm
• Tip finish: polished stainless steel
• Fitment information: No valves - 76 mm tube diameter
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (UK)

Compatible vehicles

• Volkswagen Golf Mk7 R 2.0 TSI 300hp (76 mm version, 2014-2016)

Not sure about compatibility with your vehicle? Contact us with your VIN before ordering.

Our most frequently asked questions

• Resonated or non-resonated? This version is non-resonated (no resonator): it is the most expressive, with more crackle on lift-off. The trade-off: a slight drone can appear at certain engine speeds on long trips. If you do a lot of highway driving, compare with the resonated version.
• No valves: the system sounds open at all times. On a vehicle with factory valves, a valve delete module may be needed to avoid a warning light (see fitting information).
• Fitting: the system uses the original mounting points. A workshop typically fits it in one to two hours.

Why choose Milltek Sport?

A benchmark among European tuners, Milltek Sport tunes each of its systems directly on the vehicle. Mandrel-bent tubing, clean welds and aerospace-grade stainless steel make for a system that lasts and sounds right.

Learn more

• Golf 7 and 7.5 R: which Milltek exhaust should you choose?
• Resonated or non-resonated cat-back exhaust: which one for your car?
• Valved exhaust: how does it work and should you keep the valves?