Cat-back Milltek Audi RS3 8P 2.5 TFSI 2011-2012 - non-resonated - GT90 Titanium tips

Milltek Sport exhaust system for Audi RS3 8P

Replacing the original system with a Milltek Sport exhaust brings back the character that the factory setup holds back on your Audi RS3 8P engine: a rounder tone at idle, opening up cleanly through the rev range, without gimmicks.

Technical specifications

• Milltek part number: SSXAU572
• Part type: Exhaust system
• Configuration: non-resonated (no resonator), with valves
• Detail: No resonator - GT90 titanium tips
• Tube diameter: 76.2 mm (3 inches)
• Outlets: 2 GT90 outlets, 90 mm each
• Tip finish: titanium finish
• Fitting information: With active valve
• Material: aerospace-grade stainless steel
• Manufacturer: Milltek Sport (UK)

Compatible vehicles

• Audi RS3 8P 2.5 TFSi (S-tronic, Quattro, Sportback, 2011-2012)

Not sure about compatibility with your vehicle? Contact us with your VIN before ordering.

Most frequently asked questions

• Resonated or non-resonated? This version is non-resonated (no resonator): it is the most expressive, with more crackle on lift-off. On the downside, a slight drone can appear at certain engine speeds on long journeys. If you do a lot of motorway driving, compare it with the resonated version.
• What about the neighbors in the morning? The valves are controlled as on the original: the system stays closed and discreet on start-up or in comfort mode, and fully opens in sport mode.
• Fitting: the system uses the original mounting points. A workshop with the right equipment typically fits it in one to two hours.

Why choose Milltek Sport?

Milltek Sport designs and manufactures its exhausts in England, with mandrel-bent tubing to preserve the internal diameter and a fit developed on the vehicle. The result: a clean installation without modification, and a tone tuned to remain pleasant for daily use.

To go further

• Resonated or non-resonated cat-back exhaust: which one to choose for your car?
• Valved exhaust system: how does it work and should you keep the valves?